ARGUSA | Control de accesos

Access Gate PCO-RSV6

This is a high transit control passage, with dimensions suitable for any surroundings or location. Its structure is built in stainless steel, offering high wear and tear resistance and its brushed satin finish makes it easy to combine with any predominant colour in the area where it is going to be installed. All this unites, with excellent functionality and low maintenance, make it especially suitable for controlling enclosures where there are large numbers of people present.

The PCO-RSV6 is operated by a microcontroller system that controls all the equipment’s functions and variables, along with the various components that make up the unit (motor, electro-clutch, photocells, signage pictograms, alarms, audible signals, communications, etc.).
Controlled entry into the enclosure is operated via the closure of a circuit on the system control board; this can be done in different ways (card reader, push button, etc.). The moment he circuit receives the signal in a passage direction, it begins the motorised operational cycle by moving the panel towards the interior of the unit. Once the person has passed the panel, it closes again. It is equipped with a safety system to avoid injuries.

A standard passage is set up using one-panel gates (PCO-RSV6/1), and for banks of more than one, two-panel gates (PCO-RSV6/2) are set in between.

The panels remain closed and only retract by moving to the sides and concealing themselves within the unit when they receive an access authorisation signal from a reader or pushbutton. This allows one person to pass through, and they re-close via a photocell system when this has taken place. If two people try to pass through at the same time, the system emits an acoustic alarm signal to detect the intrusion. As a safety measure, the unit is equipped with a photocell system that stops the panel from closing and hitting users while they are still in the passageway.


Bodywork in AISI-304 or AISI-316 1.5 mm thick burnished finish stainless steel plate.

Top cover, practicable and hinged security locked through which you access inside.

Adaptation of readers or control elements on the ends of the unit, either fitted on the surface or the inside of the bodywork, depending on its dimensions and characteristics.

Illuminated signage pictograms showing the operation of the passages, the arrow in green and the cross in red.

Mechanism adapted to a determined operation, with a positioning and damping system for the panel, with a safety system in case of emergency.

Treatment of the components and greased bearings are for the whole life.

The electromechanical assembly consists of: motor, crown and worm gear speed reducer, greased for life. Direct transmission.

Electronic control panel with terminal connections for control components and accessories, fuse, transformer and programming switches.

Concealable safety-glass sliding panels, 10 mm thick.

Safety and control photocell system.
Floor mounting using base plates fixed with screws and expansion plugs, supplied with the unit.

Descarga Hoja TecnicaPCO-RSV6Descarga Hoja Técnica PCO-RSV6